-
Manfre developed the large agitator for 300,000t/a, pioneering the localization of the equipment in China. Meanwhile,It set a new record of application of high power, heavy load, extra long agitator in the industry. Manfre invested great on research of new material for agitator. Besides standard ...Read more »
-
Features as following： 1、Acid distributing should be not less than 42points/m2.The distributor has a high distributing density and can distributes evenly, which increases moisture rate and mass transfer.(Distributing points can be designed according to customer requirements.) 2、Overfl...Read more »
-
Polymer Candle Filter is designed and developed to remove impurities such as gels and other solid infiltrates from polymer melt in chemical fiber, textiles and plastic industries. These filters are exposed to High Temperatures and Pressure. The strength and performance of the filter are very crit...Read more »
-
Manfre Fiber bed Mist Eliminators for highest quality requirements at the removal of mists and aerosols. Made of special glass or special polypropylene fibres, our Fiberbed Mist Eliminators reliably perform in a wide range of separation tasks in many industrial processes. With a separation effici...Read more »
-
Process design and equipment selection of Nonferrous Metal Co.’ s 700 kt/a sulphuric acid plant based on copper smelter off-gas are described.The plant adopted a cleaning section consisting of two-stages DynaWave scrubbers,packed cooling tower and two-stages wet electrostatic precipitators...Read more »
-
MECS brink filters (mist eliminators) for sulphonation plant. ► It can effectively protect fans and heat exchangers, prevent catalyst poisoning, ensure balanced production, prevent atmospheric pollution, and protect the environment when used after the drying tower in sulfuric acid production or a...Read more »
-
The sintered fiber media replace the fine filtration wire mesh. The process of producing the filter remains the same, but the results and applications are different. Metallic fiber felt developed by Manfre is made using stainless steel fibers of minimal diameters and varied length; the fibers are...Read more »
-
1. Brief Introduction Bag filter is regarded as important device for PP&PE production process and powder convey system which is applied for process gas recovery, convey gas recovery, venting powder and particle in air 2. Characteristic, application and technical parameter 2.1Characterstic: B...Read more »
-
1. Introduction Sintered Felt Filter is made of stainless steel fiber sintered felt, with the characteristic of high pressure, high temperature and chemical corrosion resistance. It also has good air permeability, high dirt holding capacity, long service-life, cleanable and repeat recycling, whic...Read more »
-
Bekaert（Bekipor ） Ultrafine fibers with wire diameters as low as 1.5 microns are used to provide ultra-high porosity and permeability. It can maintain extremely low filtration resistance under the working condition of filtering submicron particles. At the same time, Bekipor made of pure metal a...Read more »
-
Applications: Suitable for both direct melt spinning and chip spinning in production of polyester yarn (POY). Features： ◆ Featuring higher output, twice as high as conventional equipment per position and lower equipment investment.. ◆ Newly designed spin beam with less energy consumption by 25% ...Read more »
-
Manfre began to invest lots of money in the research and development of cleaning equipment and cleaning agent in 2011, relying on its full understanding and technical accumulation of filtration and biaxial stretching film industry, and relying on the superior military wage source. After three ye...Read more »
